![]() Always follow any manufacturer special instructions.ĭownload a printable PDF and recording form here.Discontinue use if numbness, tingling, pain or discoloration of the skin occurs. ![]() Allow the tool to do the work by using a grip light enough to maintain control.Properly position your body while moving and using the equipment.Watch for excess lengths of the air hose, which can cause a tripping hazard.Verify that workers won’t encounter electrical or gas lines while performing the work.Make sure that loose clothing doesn’t get caught in the equipment.Always disconnect the tool when you’re not using it or when you are changing accessories.Never use compressed air to blow dirt or debris from your clothes.Never point a compressed air hose at yourself or anyone else.Never exceed the tool’s designated operating pressure.This prevents you from unintentionally shooting the chisel or tool from the barrel. Inspect the safety clip or tool retainer for proper operation.Make sure safety or holding pins used on all hose connections are in place.Check all couplings and accessories on all compressors and ensure that only correct, compatible couplings are in place.Inspect the jackhammer or chipping hammer for damage and make sure all controls and safety interlocks work properly.N95 or greater respiratory protection unless you’re using water for silica dust control.Durable work boots with protective toes.WEAR THE CORRECT PERSONAL PROTECTIVE EQUIPMENT Here are some common-sense tips provided by tool manufacturers. These compact battering rams pack a lot of punch, and they can be dangerous if you don’t use them properly. Workers use compact pneumatic chipping hammers and jackhammers to do the job. Chipping and hammering for concrete removal are common work activities in bridge work and repair. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |